The structure of the filling machine mainly includes a storage tank, a filling host and a variable frequency speed control conveyor belt.
The storage tank is located at the top of the machine and is a normal pressure tank with a liquid level sensor and a feed solenoid valve. The liquid sent from the previous process is put into the tank through the solenoid valve. When the liquid level reaches the appropriate height, the liquid level sensor sends a signal, and the electrical control part controls the solenoid valve to close and stop feeding. When the material surface drops to a certain position, the feed solenoid valve feeds again. There is a discharge port at the bottom of the storage tank, which is connected to the suction pipe of the filling host through a pipeline. When the host is working, the liquid in the storage tank is pumped into the piston cylinder and then filled into the bottle through the nozzle.
The filling host is the main device to complete the filling action. There are several filling heads at the front of the host, and liquid pumping cylinders are installed on both sides. Each cylinder corresponds to a filling head. The liquid in the storage tank is pumped into the cylinder, then pressed out, and poured into the corresponding bottle through the filling head. There is a micro cylinder on the filling head that drives a small piston to open and close the nozzle of the filling head, acting as a valve. The entire filling head can rise and fall. When filling is about to begin, the nozzle is inserted into the bottle, and the small piston is opened at a certain distance from the bottom of the bottle to start filling. The filling head rises while filling until the nozzle is closed when the filling is completed and rises to the bottle mouth position.
The variable frequency speed control conveyor belt part is controlled by an electric motor to achieve stepless speed change and ensure the economic operation of the system. After the motor is started, the empty bottles are fed in from the conveyor belt and the bottles begin to be fed. When it is detected that the number of bottles fed is the same as the number of filling heads, the conveyor belt stops feeding the bottles and starts filling. After the filling is completed, the conveyor belt continues to run and sends out the filled bottles.
